Author Topic: Atc 250r fender seat mount (Read 11043 times)

mrtwidster1 · « **on:** July 23, 2014, 12:50:44 PM »

Here is the rear mount I had made for my ATC 250r im building. I am working on the front one also. These will let me adjust the seat a little closer to the tank. I am going with an aftermarket desert tank and desert seat and I wanted the fitment to be closer. I am pretty sure i will put some clip pins below the knobs just so I don't accidentally loose a knob. Everything is stainless. I had the knobs machined. I layed out the holes and my son punched them for me. I polished. Still have some pits, but not going for show quality. The large holes are to lighten it up some.

JesseA420 · « **Reply #1 on:** July 23, 2014, 02:35:26 PM »

the adjustability of this is a great idea to get ur fenders and seat to line up. i like it!

fourtrax · « **Reply #2 on:** August 02, 2014, 04:04:07 PM »

Very nice part...should be able to hold the seat tighter against the front bushings, awesome!

mrtwidster1 · « **Reply #3 on:** August 05, 2014, 06:51:56 PM »

Thank you

Daamud · « **Reply #4 on:** September 21, 2014, 10:21:09 PM »

I like this. I may have to duplicate this in aluminum for myself.

mrtwidster1 · « **Reply #5 on:** September 23, 2014, 10:59:27 AM »

Just a note... I know that aluminum is lighter, but i wanted some "different" items for my ATC build. There a lot of "one Off" parts on this project, and the stainless is just for the reason of being "different". Yes it adds weight, but this project is not about "Go" or "Show". I am going to ride it on a daily basis, but it will be treated well.
Thanks for all the kind comments!

The_Steve_Man · « **Reply #6 on:** September 23, 2014, 01:43:41 PM »

Pumashine makes them out aluminum.