Author Topic: cr250 pedal (Read 5848 times)

zcarlson12 · « **on:** May 21, 2015, 10:03:17 PM »

My Laeger frame uses one but I have it all mounted up and it's hitting the propeg. Has anyone ran into this problem? Can you adjust the rear m/c shaft to make it longer? That might put the clevis lower raising the pedal if it can.

zcarlson12 · « **Reply #1 on:** May 22, 2015, 08:59:12 AM »

Tbone07 · « **Reply #2 on:** May 22, 2015, 11:04:05 AM »

Wish I could help you on this one. My Laeger uses a TRX pedal

zcarlson12 · « **Reply #3 on:** May 22, 2015, 11:27:48 AM »

Thanks Tbone. My no-link also used a TRX pedal but this one uses a cr for some reason.

JesseA420 · « **Reply #4 on:** May 22, 2015, 05:51:17 PM »

looks liek the way its hanging way down, the brake MC rod just needs to be way longer

ryanowarrior · « **Reply #5 on:** May 22, 2015, 11:32:57 PM »

My Crf is the same way...ended up havin to file some off the pedal

what rear MC are u using?

zcarlson12 · « **Reply #6 on:** May 25, 2015, 11:01:58 AM »

I agree Jesse. I guess I'll be looking at doing what you did with the crf m/c. Ryano, I'm using the trx one right now.

2ndmoto · « **Reply #7 on:** May 25, 2015, 01:06:13 PM »

You should have a little bit of adjustment at the clevis. I had a similar issue with alignment using a trx mc. I used a banshee clevis, which is a bit longer. You can find some different clevises on McMaster Carr's website also.

Good luck
-Jason

zcarlson12 · « **Reply #8 on:** May 26, 2015, 08:47:51 AM »

Thanks Jason I'll check out the Banshee clevis today at work. I do have a little bit of adjustment left at the clevis so I guess it will take some playing around with. Nothing like a custom build!

TRX250RACER · « **Reply #9 on:** May 26, 2015, 06:35:58 PM »

A coupling nut and a short piece of threaded rod should do the trick.

2ndmoto · « **Reply #10 on:** May 27, 2015, 01:30:55 AM »

The banshee clevis pin is slightly larger diameter than the trx. I had to drill the hole on the pedal to make it work.

Good luck
-Jason

zcarlson12 · « **Reply #11 on:** June 03, 2015, 08:58:15 AM »

I ended up lowering the R clevis down a bit and did a little tweaking on the pedal. It's just about perfect but eventually I'll use a longer clevis. Thanks for everyone's help.