Author Topic: Billet bowl Pwk carb (Read 2442 times)

Morse250r · « **on:** April 17, 2016, 09:05:55 PM »

Bought from a member on here. I opened and then put it on the shelf. One corner is ground a bit I'm guessing for clearance on the case. 60 shipped very nice

fast350r · « **Reply #1 on:** April 18, 2016, 01:24:12 AM »

Does it have the cap at the bottom

Sent from my iPhone using Tapatalk

Morse250r · « **Reply #2 on:** April 18, 2016, 05:20:50 AM »

No as pictured. Remove it from the stock bowl looks like

Aceman · « **Reply #3 on:** April 18, 2016, 09:13:37 PM »

I'm staring at it trying to figure out how it even bolts up? I see the inner 4 holes next to the bowl o-ring, those are the original bowl holes that line up with the carb, right? But they're recessed inside this bowl where you can't put screws through them? What am I missing? Are you supposed to run screws through the outside holes into what?

JesseA420 · « **Reply #4 on:** April 18, 2016, 10:07:39 PM »

Quote from: Aceman;66718

I'm staring at it trying to figure out how it even bolts up? I see the inner 4 holes next to the bowl o-ring, those are the original bowl holes that line up with the carb, right? But they're recessed inside this bowl where you can't put screws through them? What am I missing? Are you supposed to run screws through the outside holes into what?

kind of hard to tell in the pics, but it is a 2 piece bowl. you attach the top half of the bowl to the carb first with the stock location screws to the carb body, then the bottom half of the bowl attaches to that with the outer 4 screws.

Morse250r · « **Reply #5 on:** April 19, 2016, 11:07:43 AM »

^^ exactly right the inner holes you put the screws from your existing bowl in then you bolt the billet bowl up to that plate

sameltoe · « **Reply #6 on:** April 20, 2016, 10:01:04 AM »

Does it use the same type seal as the bowl? I'm just wondering about replacement.

Morse250r · « **Reply #7 on:** April 20, 2016, 09:00:33 PM »