Author Topic: honda-yamaha wheel drilling (Read 3642 times)

trx250scar · « **on:** September 06, 2014, 09:52:34 AM »

Does anyone have a plate to drill Honda 4x110(rears) to Yamaha blaster 4x100 (rears). It's kind of a long shot for the blaster pattern, so does anyone know if a blaster stock axle accept stock banshee hubs(4x115). I got a good deal on some almost new 18" paddles and wheels that will go great on my wife's blaster.

jcs003 · « **Reply #1 on:** September 06, 2014, 10:36:41 AM »

i remember back on atvriders a guy had drilling templates. another option is to lay them out and center punch then drill.you could also have a machinist drill it for you.

john

supernutt · « **Reply #2 on:** August 09, 2015, 02:18:48 PM »

I am having the same issue here. I was given a set of 4x100 rear wheels with nice sand skate 2's on them. I am wondering if anyone knows of another rear hub that fits the 250r spline but is 4x100 bolt pattern? New wheels are $100 for the cheapest set I can find and I am sure I can buy used rear wheel hubs much cheaper.....

Pumashine · « **Reply #3 on:** August 09, 2015, 02:40:20 PM »

Dave Moore was selling drilling templates on Facebook. I cut 1/2" plate with both bolt patterns. You bolt the template on and use the plate as a drill guide to put in 4 new holes.

I think Blaster ans Banshee are the same so there are proly alot of them out there.

trx250scar · « **Reply #4 on:** August 09, 2015, 06:11:38 PM »

Blaster and banshe rears are not the same but the fronts are.

The norm · « **Reply #5 on:** August 11, 2015, 11:07:41 PM »

The splines on the blaster axle are the same as the banshee, yfz, and raptor. I have a template that I made to adapt the blaster wheels to Honda pattern. The problem is that the valve stem is kind of in the way of one hole.

The norm · « **Reply #6 on:** August 11, 2015, 11:10:25 PM »

You can use the rear hubs of a yfz, raptor, or banshee

JesseA420 · « **Reply #7 on:** August 12, 2015, 07:04:36 AM »

i have a set of raptor hubs u can have, the splines are a little worn but if you swartzanegger the axle nut it will work fine.