I got some of the o rings for my exhaust flange from
Onski326 connected to a Paul Turner race pipe. I installed them on my ESR exhaust flange, I used 2 for the pipe side and the thicker of the 3 on the motor side. They fit and sealed nicely. I started the motor and usually I see a little smoke creep out from between the pipe and the flange, with
Onski326's o rings it was sealed. I will be getting some hours put on the bike in a month or 2
realized after top end rebuild I needed a rod bearing too, I will replace and hope to be in Glamis on presidents day. Let's see how they hold up. [ATTACH=CONFIG]7685[/ATTACH][ATTACH=CONFIG]7686[/ATTACH][ATTACH=CONFIG]7687[/ATTACH]
