Topics

1

For Sale - Parts / Brand New NPRD(CLEIGH) ESR 350 NON PV top end + ESR cases

« on: December 15, 2014, 01:34:10 PM »

I've decided to run my ported 265 top end for now and I'm selling my ESR CLeigh ported 350.


ESR 350 NON PV topend XC ported and set up for 104+ octane race fuel. This top end is brand new(0 HRS) and came as the builders kit. I sent it off to Neil and he had his machinist bore out the cylinder with .0030 piston to bore clearance. All gaskets and seals INCLUDED but not pictured.


I'm wanting $950 shipped which is basically the cost of the kit, port job, and bore job minus all the shipping cost I paid. Plus you'll save yourself the downtime

2

Engine and Bottom End / Any OEM clutch baskets look like this?

« on: October 21, 2014, 12:00:25 AM »

I wasted half the day today tearing down a spare bottom end that I have and the basket looks similar to this one. I'm hoping that it is aftermarket and at least some good will have come from today's work. Do any of the OEM baskets have the open slots in them?

3

Wanted / top engine mount

« on: October 11, 2014, 01:11:16 PM »

Looking for a top engine mount for the head or I might have to go the ESR route.

4

The Mad Scientist / Fabricators? Trx250r full fender mounts

« on: October 06, 2014, 11:45:37 AM »

Anybody interested in making some full fender mounts for us guys not running race cuts. I have a set that I would be willing to lend out for fab work. I think these would be easy to do and whoever does them will surely sell plenty of them. PM me if interested.

5

For Sale - Complete Bikes / good arens/lsr deal for someone

« on: October 03, 2014, 02:41:50 AM »

http://macon.craigslist.org/cto/4631953716.html

Ive talked to the owner once or twice and he says its been in the corner of his garage the past 6 years. He says it ran when he parked it and shouldn't need much to fire her up. I believe he'll take around 2500-3000. I was looking to get it but decided to continue my build. I figured I'd pass on to a fellow member

Located near Macon GA

6

Introductions / checking in!

« on: March 02, 2014, 09:32:43 PM »

Hello guys. I'm frequent on a lot of the other R sites and found this one the other day. I currently have a lovins framed R that is on the back burner because of my current atc trike build. I mostly lurk and take in info but I try to give input where I have some knowledge. I just would wanted to drop a line