Author Topic: Who ported this cylinder (Read 3610 times)

Outlaw525 · « **on:** September 14, 2013, 08:40:46 PM »

Take a look at this cylinder it is a pro x casting 330 bolt on kit. Not sure but might off started it life as a regular 330 kit. Has one casting stamp below the exhaust that is 1290. And one that was engraved in the lower intake side 21195. If you know who might of done the work on the cylinder let me know.
Well I will keep trying to up load pics

Outlaw525 · « **Reply #1 on:** September 14, 2013, 08:52:04 PM »

I thank the cylinder has Been bead blasted at one time

rsss396 · « **Reply #2 on:** September 14, 2013, 09:08:06 PM »

if no markings then anybody with a dremel or die grinder could have done it, it looks resonable so no worries, just run it and have fun!

udontknowme · « **Reply #3 on:** September 14, 2013, 09:57:28 PM »

hell anybody could of done it. seen jerry hall and packards stuff that never had identifying markings

Outlaw525 · « **Reply #4 on:** September 15, 2013, 12:03:06 AM »

Yea I know any one could of done it that is why I listed the id numbers off the cylinder hoping some one would recognize them.

Pumashine · « **Reply #5 on:** September 15, 2013, 12:13:16 AM »

The bigger companies use the ID numbers. CT, ESR, Duncan, and many more. They are usually stamped numbers. Some use an electric pencil.

Hawaiiysr · « **Reply #6 on:** September 15, 2013, 02:45:13 AM »

Like Arlan @LED. I gave him a call with a # engraved on a cylinder ported by LRD. He knew when he worked on it, what it was ported for, along with the info for the matching head. Easy guy to speak with.