I am regrettably parting out my 86 250r. i need the money so its gotta go. nothing is torn down yet so i want to make sure i have plenty of interest.
all prices are + shipping. my ebay is kevhes11 which is where all unsold parts will go. id much rather sell here. any questions feel free to text call or pm.
I am located in manteca California and local pick up is okay. i stand behind these parts. i am not here to rip anybody off.
I just built this quad in may/ june check my old post you can see a lot of this quad come about.
the carb, rear axle, and rear paddles are gone. please please please ask questions before you buy, i have no problem taking specific pictures from specific angles to satisfy a buyer.
350 Cylinder TRX-9 Port from ESR (needs piston/hone)-500
Complete bottom end
4 mil stroker crank hot rod. new bearings. complete trans, flywheel,no covers-600
JL engineering, custom hand built and chromed +4 swinger, new bearings with tm works guide and slide.- 500
plastics custom hand painted, some defects (ask for close ups)-300
seat with custom cover-165
+2 lonestar? chrome a arms
with new tie rods and ends - 325
Front sand paddles w/ rim- 125
trx-5 pipe with silencer and pipe mount. center mount. -250
K&n air box delete air filter 30
custom 450 pegs welded to fit 86-87 250r- 25
rear grab bar-35
all 4 hubs-100
steel braided brake line (+2 front and +4 rear)-75
+1 stem (not sure brand)-90
aluminum radiator -150
cascade temp guage -15
custom PC frame, no cracks( that ive noticed pre tear down)- 250 w title
stock shocks front shocks are just starting to leak. they are silver now. -75 for the three.
misc- bars, rtc levers, brake/shifter, tank, block off plate, whatever else.
stock pegs, stock swinger, stock tie rods
i'll update more as i go on. i hate to do this. Please keep in mind, the quad is not taken a part yet. i will tear down as the parts sell, which shouldnt be too hard since im keeping the bottom end in tact.
