Author Topic: hotrods crank hits the case. (Read 2838 times)

d-rock · « **on:** December 23, 2014, 07:04:01 PM »

Hi, guys. I was assembling my engine today. the +4 hot rods crank hits the cases on both sides. It looks like the lower end of the rod has been machined but not enough to clear. Has anyone else ran into this. I could just notch the cases but I wanted to ask first.
Thanks. Derek .

ccaiazza · « **Reply #1 on:** December 23, 2014, 08:33:37 PM »

Cases have to be relieved for the plus 4

udontknowme · « **Reply #2 on:** December 23, 2014, 09:55:26 PM »

if you have new bearings installed already youll want to be sure theyre well covered or youll have them full of metal chips

d-rock · « **Reply #3 on:** December 23, 2014, 10:15:07 PM »

I only installed the crank in the left case, i'll mark it and press the crank out again.
thanks.