What Grab Bars Fit TRX250R?

[Pontas]

Can someone confirm what grab bars can be used on the 250R? LTZ 400? TRX 400 EX? TRX 450R? I've read some compatibility charts, but I was wondering if someone has experience mounting hardware from other models on the 250R.

[havinnoj]

Moved this to a new thread.

[Pontas]

Oh, sorry for the incovenience and thanks for moving my question to a new thread.

[Piney0]

Not sure if this info helps or not.

86 and 87 TRX have a wide bolt pattern spacing where the grab bar bolts to the sub frame
88 and 89 TRX have a narrow bolt spacing where the grab bar bolts to the sub frame

Also any 400ex I've seen the grab bar didn't unbolt from the sum frame,  they were the same.

That's all I know, hope this helps

[Pontas]

I forgot to say I have an 88.

Didn't know about that 400 EX fact, although I know a guy that has one. I have to check that out.

Also, I have a friend with a Arctic Cat DVX 400, that is basically an LTZ 400, that I can check if his grab bar fits on my 250R. I'll post here if it fits.

[sameltoe]

I have an 88/89 and a 04/5 trx450r rear bumper on it.

[sangheraent]

I have a rear bumper that I took off a 400ex yz426 hybrid. The guy that sold me the frame told me it was a 400ex frame modified to fit a 426. I have a walsh frame believe it is 88/89

[Wrench U]

Bolt patterns easy to drill. The width is  more critical. Trx450r 04-05/ 06-09(u need to cut exhaust mount off) is the right width. Ltz400 is also the right width. I haven't confirmed 400ex but I think the 450r (04-05) use the same part numbers. This was a thread a while back. I took the actual width measurements.

[Piediddy]

There is a nice RIS Designs rear bumper on EBay but its for a Raptor 250. I could redrill holes but not sure about the width.