TRX250r.org
« previous next »
Pages: 1 [2]   Go Down

Author Topic: 1st. Gear Sputter, Pop  (Read 6797 times)

Offline rsss396

1st. Gear Sputter, Pop
« Reply #15 on: September 28, 2013, 10:34:57 PM »
Bottom end looks just right ;)  yeah that plug looks pretty rich youneed to lean her down
Logged
Anyone looking for a great builder I highly recommend the following.
For CP products dealers I would recommend:
Arlan at LED(site sponsor), Pete Schemberger at Hybrid Engineering, Mat Shearer at Shearer Custom Pipes, Dennis Packard at Packard Racing, and Nate McCoy of McCoys Peformance.

Other great builders I also would recommend: Neil Prichard, Jerry Hall, Bubba Ramsey and James Dodge.

Offline PORTED R

1st. Gear Sputter, Pop
« Reply #16 on: September 28, 2013, 11:18:26 PM »
Lean that needle one clip at a time if its midrange
Any new wide open plug chops ?
Logged
McCoy ProX 350 5mil Duner
McCoys Performance -1-530-476-2222

Offline F-Red

1st. Gear Sputter, Pop
« Reply #17 on: September 30, 2013, 12:50:55 PM »
As you guys stated, she was too rich. Need to get more seat time for WOT plug chops. But very happy with the results, thus far. Thanks for the help.
Logged
Want To See My Wieners?

Offline rk88r

1st. Gear Sputter, Pop
« Reply #18 on: September 30, 2013, 07:06:30 PM »
Cool, Arlan has some good advice on needles in another thread.
Logged
\'99 Laeger narrow, cr link, +3+1 protrax, Peps, with a LED 363
\'88 265 pv peps
One other \'88
Pages: 1 [2]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38