TRX250r.org
« previous next »
Pages: [1]   Go Down

Author Topic: bore size ?  (Read 2449 times)

Offline kevin wcmo

bore size ?
« on: January 21, 2014, 05:01:59 PM »
on a 86 jug with the extra thick sleeve installed with the stock 86 length rod, what is the max bore on these?  i have seen pistons up to 69.5, but i thought i have seen builds with a 72mm bore on a stock looking jug.  is that right?  and if so, what pistons are they using?  thanks
Logged

Offline kevin wcmo

bore size ?
« Reply #1 on: January 21, 2014, 08:43:21 PM »
is the sleeve that is required to be relieved for the head studs considered a bb sleeve?  if so, where is a source for the pistons?  thanks
Logged

Offline rsss396

bore size ?
« Reply #2 on: January 22, 2014, 06:52:11 AM »
The 72mm stock cylinders have custom sleeves installed in them. LA sleeve can do this but these are very prone to head gasket failure, not that they can't work but a new ESR cylinder is a much better investment.
Logged
Anyone looking for a great builder I highly recommend the following.
For CP products dealers I would recommend:
Arlan at LED(site sponsor), Pete Schemberger at Hybrid Engineering, Mat Shearer at Shearer Custom Pipes, Dennis Packard at Packard Racing, and Nate McCoy of McCoys Peformance.

Other great builders I also would recommend: Neil Prichard, Jerry Hall, Bubba Ramsey and James Dodge.
Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38