Author Topic: SR Engineering billet TRX500R winter project (Read 23238 times)

atv fan 28 · « **Reply #30 on:** October 24, 2014, 11:26:22 PM »

I remember Bio on here had a billet swingarm at Lil Sahara back a few years ago. It looked sick just as these do.

rsss396 · « **Reply #31 on:** October 25, 2014, 08:00:18 AM »

Cool!

jcs003 · « **Reply #32 on:** October 25, 2014, 10:09:42 AM »

what type of aluminum are you using for the swingarm? 7050, 7075??

john

SRE · « **Reply #33 on:** October 29, 2014, 03:54:11 PM »

rsss396 · « **Reply #34 on:** October 29, 2014, 07:24:42 PM »

Lonestar made these back in the day but I know allot of people complained they flexed and twisted to much

SRE · « **Reply #35 on:** October 29, 2014, 09:14:38 PM »

It is only a plus 6". I m sure it will twist but it should be fine to run on a drag bike.

Bio86 · « **Reply #36 on:** October 30, 2014, 01:59:24 PM »

I did a +3 6061 and welded 3 cross bars and thru bolt for the dog bone and even it twisted some. Definitely awesome being aluminum though, they look very nice.

SRE · « **Reply #37 on:** December 30, 2014, 05:37:11 PM »

Langbolt · « **Reply #38 on:** December 30, 2014, 09:41:24 PM »

Another one ? I see from an earlier post it was in an '88-89 frame and now it's in an '87 ? Or is there 2 of these being built ? Try and get yourself a Cr500 Pro Circuit pipe.....they're much easier to get to fit into a 250R frame.

Looks Great! Keep up the great work....and keep us posted on your progress.

SRE · « **Reply #39 on:** December 30, 2014, 10:07:33 PM »

the first motor is in a 88 frame. i had a couple fmf pipes from the bikes that were sitting around. this was the only frame i had without a motor. this motor has both a stock 500 and a liger pattern. We have two motors too be built with this setup.

broken1 · « **Reply #40 on:** December 31, 2014, 02:11:01 AM »

Beautiful work! I wish I had half your talent.

SRE · « **Reply #41 on:** May 02, 2015, 02:15:46 PM »

it is finally warm out. time to finish these motors.

ride red #1 · « **Reply #42 on:** May 02, 2015, 10:41:11 PM »

Quote from: Uscared;44941

It's only fitting that you have a billet swing arm to go with the billet engine.

Nice..

cswelding · « **Reply #43 on:** May 27, 2015, 08:47:28 AM »

When can we buy. This is by far the coolest motor I've ever seen go into a quad. If these cases ever becomes available I would by them. I just put my 05 450 for sale so I can make my 500 scream again and this is exactly what I need